Joyetech eGo One CLR Atomizer Head is the specially designed atomizer head for Joyetech eGo One. With CLR head, you are able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun.
5 PCS Pack
Pre-made coil resistance: 1.0 ohm;
Pre-made coil diameter: 0.4mm;
Suggested coil resistance: more than 0.3 ohm;
Suitable for eGo ONE atomizer, eGo ONE Mini atomizer, eGo ONE Mega atomizer;
Rewickable Cotton: The CLR Atomizer Head comes pre-built with organic cotton. The cotton can easily be replaced as needed.
Rebuildable and Reuseable: The CLR Atomizer Head is a unique type of RBA. For advanced users, the CLR Atomizer Head can easily be taken apart, so that a new coil can be installed with ease. For standard users, the CLR Atomizer Head can easily be reused when the coils accumulate buildup. Simply remove the cotton, dry burn the coils, let it cool, and then run the coil under cold water. After the coil is dry, new cotton can now be applied to the coil for use.
Liquid Valve Control: The Liquid Valve Control can be adjusted to your personal preferences.
1. Prepare the heating wire. Standard heating wire for example. Take a piece of heating wire of around 60millimeters long and roll the heating wire; Reserve around 8.5mm on one side, and then rotate 5 - 6 circles reserving around 7mm on the other side. Bend a little at bottom ends.
2. Install the regulating ring to the atomizer tube and screw it tightly. This ring could adjust the amount of liquid entering.
3. Put the heating wire into the tube, and keep it in the center position.
4. Put the long end into notch, pass the short end through the insulating ring.
5. Install the insulating ring and connection base to the tube.
6. Adjust the position of the heating wire and make the cotton cross the heating coil, cut off the redundant cotton to keep flush with liquid entering notches.
7. Screw on the top cap tightly.